Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
72
Item Description Parameter
ARQ If "Unicast" is specified for
[Streaming mode], specify whether
to enable the ARQ error correction
method.
- Enable
- Disable (Default)
TOS Set IP packet TOS value. Hexadecimal number between 00 and ff
(Default: 0)
Protocol If "Multicast" or "Unicast
(simplex)" is specified for
[Streaming mode] and "Disable" is
selected for [FEC], specify the IP
transport protocol.
- UDP
- RTP (Default)
* If "UDP" is selected, "Standard TS" is
fixedly selected for [Stream format].
Stream format If "Multicast" or "Unicast
(simplex)" is specified for
[Streaming mode], "Disable" is
selected for [FEC], and "RTP" is
specified for [Protocol], specify
the stream format.
- Standard TS
- Time stamped TS (Default)
Pro-MPEG FEC If "Standard TS" is selected for
[Stream format], specify whether
to generate Pro-MPEG FEC
packets.
- Enable
- Disable (Default)
Pro-MPEG Matrix If "Enable" is selected for
[Pro-MPEG FEC], specify the
generation matrix values for FEC
packets.
A value of [4 to 20] x [4 to 20] can be set.
(Default: 10 x 10)
* N x N values that exceed 100 cannot be set.
Output
interface
settings
(Sub
encoder
ethernet
port)
Streaming port Specify the own device port
number used for sending streams.
0, 1024 to 64000 (Default: 0)
* If 0 is set, a port number between 64100 and
65000 is automatically selected.
Specify the port number of the
destination device used for sending
streams.
1024 to 64000
(Default: 5010)
Unicast request
port
Specify the port number of the own
device used for receiving a unicast
streaming request.
1024 to 64000
(Default: 9910)
ARQ control port Displays the port number of the
own device used for controlling
ARQ.
You cannot specify this item.
* This item is automatically set according to
the [Streaming port] setting.
Pro-MPEG FEC
port
Displays the port number of the
own device used for sending
Pro-MPEG FEC.
You cannot specify this item.
* This item is automatically set according to
the [Streaming port] setting.
Main
encoder
settings
(Encode)
Encoding operation Specify whether to start encoding
operation after the device is started
or after the main encoder settings
are changed.
- Enable
- Disable (Default)
Bit rate mode Specify how the bit rate is
specified.
- Video bit rate (Default)
- System bit rate