Filter
Top Products
Chapter 2 Installation & Operation
IP-900 Series
10
2.1 Updating the Software
This section explains the procedure for updating the software for the IP-900 series as well as the
procedure for applying for an HD option license.
The software for the IP-900 series is pre-installed at product shipment. For this reason, you do not need
to install the software before using the IP-900 series. When updating the software to the latest version,
use the following procedure.
2.1.1 Installation Procedure
(1) Access method
Access IP-900 series Web page from the Web browser.
The default IP address of the IP-900 series as it is shipped from the factory is 10.0.0.1.
Temporarily disable the proxy setting on your Web browser and then type "http://10.0.0.1" to
access the Web page.
(2) Installation page
IP-900 ENCODER or IP-900 DECODER screen appears. Click SOFTWARE
MANAGEMENT in the left frame of the Web browser screen. The Software management
window (installation, etc.) appears in the right frame of the Web browser screen.
Figure 2-1 Installation Window
2.1