Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
85
3.3.2 Encoder Address Report
* This function is enabled only when the device operation mode is encoder mode.
* Encoder address report is a group of setting items, of which 10 sets can be registered
independently by selecting data numbers as in 3.2.1 Configuartion Data.
To dynamically obtain an IP address using DHCP or PPPoE, the IP address needs to be known. If the
report destination is specified in advance, the obtained IP address is reported to the specified destination.
IP-900 series decoder or a PC running a certain type of software (*1) is normally specified as the report
destination. If the decoder is specified in advance as the report destination, you can specify an encoder
from the Web screen to request streaming. (See Section 3.5.2 for information about decoder setting and
operation.)
The same screen is displayed for Encoder Address Report
, Main Encoder, and Sub Encoder, which are
located in the frame on the left side of the Web screen. By clicking on the tab for each, the Encoder
Address Report window for each is displayed at the top of the frame on the right side.
Make the required settings by referring to Table 3-23 Setting Items for Encoder Address Report.
Figure 3-22 Encoder Address Report Window