Filter
Top Products
Welcome
Product Authorization
6 CIMPLICITY Logic Developer - PLC Version 4.00 GFK-1918D
1
To move the authorization to another computer
You can run the software on only the computer that the Product Authorization was
run on. If you want to develop your projects on a different computer, you need to
complete the following steps to move the authorization from one computer to
another.
1. Install Logic Developer - PLC on the computer that the authorization will be moved to. Run the Product Authorization
program from the Start menu > Programs > CIMPLICITY Machine Edition > Product Authorization.
The Product Authorization dialog box appears.
2. Click Software.
There is a Target Site Code on the top right-hand side of the screen. Write down
this site code carefully. It must be accurate for the move to work. You will need the
Target Site Code when you move the authorized software from the source
computer.
3. Click Add.
The Product Authorization wizard appears.
4. Click Authorize by disk.
At this point, you need to go to the source computer that has the authorized
software, and move the authorization to a disk.
5. From the source computer, run the Product Authorization program and click Software.
6. Click Move, and then click OK. Enter the Target Site Code that you wrote down from Step 3 and click Next. Verify
that the site code is correct and click OK.
7. Insert a blank formatted floppy disk into the floppy drive and click Next.
The authorization code will be moved to the disk and a dialog box should appear
telling you it was successful.
8. Click OK.
9. Go back to the computer to which you are moving the authorization and insert the floppy disk.
The screen that is asking for an authorization disk should be displayed.
10. Click Next.
11. Click Finish.
A screen should appear telling you the move was successful.
12. Click OK.
The authorization has now been moved to the new computer.