Filter
Top Products
PCI switch card
Before you begin:
v Read “Safety information” on page 127
v Review the information in “Before you begin” on page 50
1 Switch card latches
2 Switch card assembly
1. Power-off the server, if it is on.
2. Disconnect the server from the electrical outlet.
3. Remove the top cover (see “Removing the server top cover and bezel” on
page 53).
4. Disconnect the switch card cable from the system board.
5. Disengage the switch card:
a. Press the switch card latches toward the front and sides of the server.
b. Push the latches through the notches.
6. When the switch card latches have been disengaged from the notches, gently
pull the switch card free and lift it up and out of the server.
Note: You may have to tilt the top of the switch card toward the front of the
server when removing it.
7. To replace the switch card, reverse the steps above.
FRU information (service only) 93