Filter
Top Products
Installing a hot-swap power supply
The following illustration shows how to install a hot-swap power supply.
Note: The illustrations in this document might differ slightly from your hardware.
Filler panel
Power supply handlePower supply
DC power light
AC power light
To install an additional power supply:
1. Remove the filler panel.
2. Place the handle on the power supply in the open position.
3. Slide the power supply into the chassis and close the handle.
4. Plug the power cord into the power supply; then, into a properly grounded
electrical outlet.
5. Verify that the DC Power light and the AC Power light on the power supply are
lit, indicating that the power supply is operating properly.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label
attached.
Hazardous voltage, current, and energy levels are present inside any component that
has this label attached. There are no serviceable parts inside these components. If
you suspect a problem with one of these parts, contact a service technician.
70 IBM xSeries 350 Type 8682: Hardware Maintenance Manual