Filter
Top Products
Power backplane assembly
Before you begin:
v Read “Safety information” on page 127
v Review the information in “Before you begin” on page 50
1 Holding screws
2 Power backplane
To remove the power backplane assembly, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the top cover (see “Removing the server top cover and bezel” on
page 53).
4. Remove the system board assembly (see “System board assembly with
backerplate” on page 95).
5. Disconnect all cables to the power backplane.
6. Remove the three holding screws.
7. Lift the power backplane out of the server.
94 IBM xSeries 350 Type 8682: Hardware Maintenance Manual