Filter
Top Products
Removing the server top cover and bezel
Review the information in “Before you begin” on page 50
The following illustration shows how to remove the top cover and bezel from the
server.
Note: The illustrations in this document might differ slightly from your hardware.
Top cover
Release latch
Release latch
Cover release latch
Bezel
To remove the server top cover:
1. Lift the plastic cover-release latch near the edge of the top cover.
2. Slide the top cover slightly toward the rear of the server; the cover will stop after
about 25 mm (1 inch). Lift the cover off the server and set the cover aside.
Attention: For proper cooling and airflow, replace the top cover before
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the top cover removed might damage server components.
To remove the bezel:
1. Release the two tabs at the top edge of the bezel and pull the top of the bezel
slightly away from the server.
2. Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store
the bezel in a safe place.
Installing options 53