Filter
Top Products
2. Follow any special handling and installation instructions supplied with the
battery.
3. Turn off the server and all attached devices and disconnect all external cables
and power cords (see “Safety information” on page 127); then remove the top
cover.
4. Locate the battery on the system board (see “System board component
locations” on page 42).
5. Remove adapters as necessary so you can access the battery. (See “Working
with adapters” on page 54)
6. Lift and remove the plastic dividers by pressing the latches on the top ends of
the dividers toward the dividers and lifting the dividers from the server.
7. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery toward the rear of the server.
The spring mechanism behind the battery will push it out toward you as
you slide it forward.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
8. Insert the new battery:
a. Tilt the battery so that you can insert it into the front of the socket, under
the battery clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
9. Reinstall any adapters that you removed.
10. Insert the plastic dividers into the divider guides.
11. Reinstall the top cover.
Note: You must wait approximately 20 seconds after you plug the power cord
of the server into an electrical outlet before the power control button
becomes active.
12. Start the Configuration/Setup Utility program and set configuration parameters
as needed. Refer to “Using the Configuration/Setup Utility program” on page 33
22 IBM xSeries 350 Type 8682: Hardware Maintenance Manual