Filter
Top Products
Hot Plug Solution package, the adapter device driver will not recognize the
hot-plug code. This happens because the adapter device driver only checks
the NT registry for the Hot Plug package during installation. If the PCI Hot
Plug Solution package is added after the adapter device driver is installed,
the adapter must be removed and added again in order for it to detect the
PCI Hot-Plug Solution code.
To install the IBM PCI Hotplug for Windows NT 4.0 Failover DMI Agent:
1. Download the IBM PCI Hotplug for Windows NT 4.0 Failover DMI Agent file
from the xSeries Support web page and extract the files onto a diskette.
2. Insert the diskette into the diskette drive.
3. From the Start menu, select the Run option.
4. Type A:\SETUP.EXE in the Open box.
5. Click Ok. The setup wizard opens.
6. Follow the instructions that are given by the setup wizard until the program is
installed.
7. Restart the server.
To install the IBM PCI Hotplug for Windows NT 4.0 Solution package:
1. Download the IBM PCI Hotplug for Windows NT 4.0 Solution file from the
xSeries Support web page and extract the files onto a diskette.
2. Log on to Windows NT Server as a user in the Administrator group.
3. Insert the diskette into the diskette drive.
4. From the Start menu, select the Run option.
5. Type A:\SETUP.EXE in the Open box.
6. Click OK. The Setup wizard opens.
7. Follow the instructions given by the setup wizard until the program is installed.
Windows NT Server failover setup:
To install the IBM 10/100 Fault Tolerant Adapter device drivers:
1. Add the redundant NIC adapter according to the instructions that are provided
with the adapter.
2. Use the ServerGuide CDs to install the AMD PCNet Ethernet Family adapter
device driver.
3. Do not select the Grouping box at this point; you must first restart the machine.
4. From the Windows NT Server desktop, select Control Panel, then select the
Network icon, then select the Adapters tab.
5. Highlight one of the adapters that will be in the redundant pair and then click the
Properties... button.
6. Check the Grouping box. This will show the possible combinations for redundant
pairs.
7. Select the adapter pair you want and then select OK. Note that the integrated
Ethernet controller is located at PCI C.
Two options are available for recovering from a failover condition. The options
are determined by the Enable for DMI / Hot Swap Support checkbox. If the IBM
Hot Plug PCI for Windows NT Server 4.0 package is installed, this checkbox will
appear at the bottom of the Adapter Properties panel. If you do not have the
IBM Hot Plug PCI for Windows NT Server 4.0 package installed on the server,
you will not see the Enable for DMI / Hot Swap Support checkbox.
Installing options 85