Filter
Top Products
c. Press on the rear of the adapter retention assembly and lift the adapter
retention cover.
Attention: Expansion-slot covers must be installed on all empty slots.
This maintains the electromagnetic emissions characteristics of the system
and ensures proper cooling of system components.
5. Refer to the documentation that comes with your adapter for any cabling
instructions. It might be easier for you to route any cables before you install
the adapter.
6. Remove the adapter from the static-protective package.
Attention: Avoid touching the components and gold-edge connectors on the
adapter.
7. Place the adapter, component-side up, on a flat, static-protective surface.
8. Install the adapter:
a. Carefully grasp the adapter by its top edge or upper corners, and align it
with the expansion slot on the system board.
b. Press the adapter firmly into the expansion slot.
Attention: When you install an adapter in the server, be sure that it is
completely and correctly seated in the system-board connector. Incomplete
insertion might cause damage to the system board or the adapter.
c. Lower the tab over the top corner of the adapter. Rotate the adapter
retention latch clockwise until it snaps into place.
9. Connect any needed cables to the adapter.
10. Enable the PCI slot from your operating system. (Refer to the documentation
that comes with your operating system for information about enabling a
hot-plug PCI slot.) Make sure that the power-on light for the hot-plug PCI slot
comes on.
11. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server top cover and bezel” on page 74
Cabling example for the ServeRAID adapter
You can install an optional IBM ServeRAID
®
adapter in the server to control the
internal hot-swap hard-disk drives; that is, to enable you to configure the internal
hot-swap hard disk drives into disk arrays. To do this, you must turn off the server,
disconnect the internal SCSI cable from the integrated SCSI controller on the
system board, and connect the cable to a ServeRAID adapter. Refer to the
ServeRAID adapter option documentation for complete instructions on installing a
ServeRAID adapter in the server. Refer to the Using IBM ServeRAID book on the
Documentation CD for information on ServeRAID adapters and controllers.
The following procedure describes the cable routing that is necessary when you
install a ServeRAID adapter. The following illustrations show the cabling for internal
hot-swap hard disk drives. You can also cable a ServeRAID adapter to external
hard disk drives.
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. Refer to the documentation that comes with your adapter for any cabling
instructions.
3. Cable identifiers are printed on the cables that come with the server and
options. Use these identifiers to connect the cables to the correct connectors.
For example, the hard disk drive cables are labeled HDD.
56 IBM xSeries 350 Type 8682: Hardware Maintenance Manual