Filter
Top Products
To cable the ServeRAID adapter:
1. Turn off the server.
2. Remove all adapters from the Active PCI adapter slots.
3. Remove the plastic dividers between the PCI adapter slots.
4. Press the fan assembly release latches on both sides of the fan assembly;
then, remove the fan assembly from the server.
ServeRAID adapter
Plastic
dividers
Fan assembly
release latch
5. Disconnect the internal SCSI cable from the SCSI connector (J38) on the
system board. (See “System board cable connectors” on page 43).
6. Carefully thread the disconnected end of the internal SCSI cable out of the
chassis, pulling the cable out of the opening in the chassis.
7. Reinstall the fan assembly in the server.
8. Replace the plastic dividers between the PCI adapter slots.
9. Reinstall the adapters in the PCI adapter slots.
10. The following illustration shows how to route the SCSI cable to the ServeRAID
adapter.
Installing options 57