Filter
Top Products
FRU information (service only)
Field Replacement Units (FRUs) should be replaced by qualified service personnel
only.
LED switch card
Before you begin:
v Read “Safety information” on page 127
v Review the information in “Before you begin” on page 50
8 8
1 Holding screws
2 LED switch card
To remove the LED switch card, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the top cover (see “Removing the server top cover and bezel” on
page 53).
4. Disconnect the switch card cables.
5. Remove the 4 holding screws.
6. Lift the switch card out of the server.
© Copyright IBM Corp. 2000 89