Filter
Top Products
Erasing a programmable one-touch key
1
Press
PROGRAM
,
C
, 2. The
LCD
shows:
2
Press
ENTER
. The
LCD
shows something like:
If
P
1 is the key you want to erase, skip to step 4. (However, our examples
from here will say “P3” rather than “P1.”)
3
Press the programmable one-touch key you want to erase.
Here, we select P3:
4
If you decide to erase a different programmable one-touch key, just press that
key before going on step 5.
5
Press
ENTER
. The
LCD
shows:
Important: If you want to quit without erasing the programmable one-
touch key you have selected, press
PROGRAM
. The fax will
return to step 3.
6
Press
ENTER
to erase the number.
To erase another programmable one-touch key, repeat steps 3–6. Or press
STOP
to
return to standby mode.
Printing a list of your programmable one-touch keys
You fax machine can print a list of the commands you have stored in your program-
mable one-touch keys. The list includes each key’s one-touch letter, the telephone
number, when the command should start, which command you have selected and —
if applicable — the selected call group(s) for relay broadcast initiation you have
stored in the key.
To print the list, press
PROGRAM
,
C
, 3,
ENTER
.
Programmable one-touch fax dialing
To dial a fax call using a programmable one-touch number:
1
Insert the document.
2
Adjust resolution and contrast if necessary.
3
Press the programmable one-touch key in which you have stored the number.
Your fax will perform the operation either now or at whatever other time you set.
Note: To review the details for each operation, please review the its instructions.
See page 2.28 for a list of where to find each operation.
If you programmed this key to delay its operation, the
LCD
will briefly show the
below and return to normal standby mode:
However, if you programmed this key to perform the operation immediately after
the key press, the
LCD
shows the number:
9-1-972-555-4335
** Reserved **
** Complete **
Check Prog/Enter
P3:Polling
P1:Delayed
Erase P OneTouch
Beyond the basics
2.36