Filter
Top Products
What you see on the
LCD
What it means/What to do
You tried to scan the document into the memory
but the machine doesn’t have enough available
memory to complete the operation.
If the fax received documents in the memory,
print them to clear space.
During transmission (or copying), you entered
more pages into memory than your fax could store.
Press
START
(or
COPY
) to tell your fax to keep as many
pages in memory as possible, or press
CANCEL
to
delete from memory all pages stored during this
operation (but not previous operations).
You pressed
REVIEW COMMANDS
to review upcom-
ing commands, but your fax machine doesn’t have
any stored.
You tried to print a document from memory, but
your fax machine doesn’t have any stored.
You selected an autodialer number that doesn’t
have a number assigned to it.
Either choose another autodialer number or dial
a phone number directly from the numeric key-
pad.
You tried to protect an operation but there isn’t
protection passcode stored in your fax machine.
Store a protection passcode in your machine,
then try protecting the operation again.
You selected “Mode1” in the
PIN
mask feature
and tried to use an autodialer number in which
no
PIN
has been entered.
Enter a
PIN
for that number, then try again.
You requested an activity journal or confirma-
tion report, but your machine has no record that
any fax jobs have occurred.
You tried to either transmit, copy or print the
document while the
PC
-
FAX
feature is busy.
Wait until the
PC
-
FAX
feature completes a job,
then try again.
Your machine’s thermal print head becomes
very hot.
Please wait a moment until the head cools down.
What you see on the
LCD
What it means/What to do
You tried to store a polling document in your
fax, where one has already been stored.
Wait for the fax to complete the polling opera-
tion, then try again.
The command you entered requires the use of
the printer, which is already in use. Wait for the
fax to finish printing, then try again.
A received document was in your fax’s memory
when you tried to turn off security reception or
erase the protection passcode.
Print the received document from your fax’s
memory, then try the desired operation again.
A paper jam has occurred.
Remove the jammed paper (review pages 3.2–3.3
if necessary).
Your document was not inserted correctly, or
the fax to which you are sending cannot handle
the document’s page length.
Reset the page and try again.
The command you are entering requires the use
of the scanner, which is already in use. Wait for
the fax to complete the scan, then try again.
You entered a sub-address number already
being used by another
F
-code box.
Enter a different number for your
F
-code box’s
subaddress.
You attempted to enter too many numbers or
characters for the current operation.
Press
CANCEL
to delete the extra characters, then
try again. You may want to review the opera-
tion’s instructions.What you see on the
LCD
What it means/What to do
You tried to enter too many group numbers for a
relay broadcast initiation. You can enter up to
10 group numbers.
Press
CANCEL
to delete the extra group numbers
and try again.
Too Many Loc.
Too Many Digits
Sub-Addr. In Use
Scanner In Use
Reset Document
Remove Paper
Protect Doc Stor
Printer In Use
Polling In Use
Please Wait
PC-FAX In Use
No Report
No PIN Number
No Passcode
No Number
No Doc. Stored
No Command
Memory Over Flow
Memory Full
Just in case …
3.5