Filter
Top Products
ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
3-12 Performing Network and System Management
v1.0, September 2009
To configure remote management:
1. Select Administration > Remote Management from the menu The Remote Management
screen displays (see Figure 3-7 on page 3-12).
2. In the Secure HTTPS Management section of the screen, enter number of the port that you
want to use to access Web Management Interface of the STM. The default setting is port 443,
but you can enter a port ranging from 1024 to 65535. You cannot use some ports such as 2080
and 8088 that might be used by the STM.
This section of the screen also displays the HTTPS hyperlink through which you can access
the Web Management Interface of the STM. The hyperlink consists of the IP address or fully
qualified domain name (FQDN) for the STM and the port number that you have assigned.
3. In the Access Control List section of the screen, you can specify IP addresses or IP address
ranges that you want to grant access to the Web Management Interface for increased security.
To specify a range, separate the beginning IP address and the ending IP address by a
dash (-).To allow access from all IP addresses and IP address ranges, leave this field blank.
4. Click Apply to save your changes.
Figure 3-7