Filter
Top Products
136 Troubleshooting
TPS CLI commands
The following sections describe TPS command line interface (CLI)
commands.
dsetShow command
In the dsetShow command output, the handsets have a specific Hardware
ID. The alias IP address is output, not the physical wireless handset IP
address.
In the following example, the IP Phone 2004 has an IP address of
192.168.10.100 and the WLAN Handset 2211 has an alias IP address of
192.168.10.200. The syntax of the Hardware ID is as follows:
•
first two digits—Manufacturer Location. Manufacturer Location is 18 for
the IP Phone 2004 and 30 for the WLAN Handset 2211.
•
next six digits—Manufacturer Code. The Manufacturer Codes are
defined as follows:
— IP Phone 2004 Phase 1—006038
—
IP Phone 2004 Phase 2—000ae4
—
WLAN Handset 2210—00907a
—
WLAN Handset 2211—00907a
— WLAN Handset 2212—00907a
•
last two digits—Release Code. The Release Codes are defined as
follows:
—
IP Phone 2004 Phase 1—0
—
IP Phone 2004 Phase 2—2
—
WLAN Handset 2210—0x06
—
WLAN Handset 2211—0x07
—
WLAN Handset 2212—0x08
-> dsetShow
TN IP Address Hardware ID TermType
---- --------------- ------------------ ----------
6004 192.168.10.100 180060387641c76600 i2004
600A 192.168.10.200 3000907a017e476607 i2004
value = 0 = 0x0
e2dsetShow command
The e2dsetShow command is used for the handsets in the same manner
as for the IP Phones.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.