Filter
Top Products
154 WLAN Application Gateway 2246
The Telnet method of connection is used for routine maintenance of
the system for both local and remote administration, depending on the
network.
Follow the steps in Procedure 17 “Connecting to a WLAN Application
Gateway 2246 through Telnet” (page 154) to connect to a WLAN
Application Gateway 2246 through Telnet.
Procedure 17
Connecting to a WLAN Application Gateway 2246 through Telnet
Step Action
1 Run a Telnet session to the IP address of the WLAN Application
Gateway 2246.
2 Log in to the WLAN Application Gateway 2246.
The NetLink OAI System screen appears.
Because the WLAN Application Gateway 2246 is initially
configured, the NetLink OAI System screen now has some
different options displayed.
--End--
When the configuration procedure is complete, the NetLink OAI
System screen adds a Feature Programming option. Also, the OAI Line
Configuration option is replaced by a Telephone Line Configuration option.
Configuring the Telephone Line
Each handset that uses the application features must be configured with
its line number and MAC address. The name and extension number of the
handset user can be entered. Obtain this information from the handset
Planning Worksheet. See “Planning Worksheet for Handsets” (page 164).
The handsets require special configuration. This can include configuring
options on the DHCP server or on the handset to allow it to communicate
with the WLAN Application Gateway 2246. Be sure these setting are
correct. For more information, see WLAN Handsets Fundamentals
(NN43001-505),.
The system does not allow the same handset to register to two different
lines. Press Esc to cancel any unwanted transaction.
Follow the steps in Procedure 18 “Configuring a telephone line” (page
155) to configure the telephone lines for the application.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.