Filter
Top Products
Handset error messages 191
Handset error messages
Table 26 "Handset error messages" (page 191) shows error messages
that appear on the liquid crystal diode (LCD) display of the wireless
handsets.
Table 26
Handset error messages
Short Error code Description Action
Assert Assert Errors The phone detects possible
network errors and cannot
recover without configuration
modification.
Verify the AP settings: data
rates and fragmentation
threshold.
Use the Configuration
Cradle to capture the assert
error and then send the error
to Nortel GNTS.
Code Bad Code Type The license management
setting on phone is incorrect.
Adjust the license
management setting.
DHCP DHCP Error(s) A problem communicating
with DHCP server exists.
Troubleshoot the DHCP
server configuration and the
network.
DHCP Can’t Renew DHCP The DHCP server is
not responding to a
lease-renewal attempt.
Troubleshoot the DHCP
server configuration and the
network.
Duplicate Duplicate ID Two phones are configured
with the same IP address.
Configure a valid static
IP address for the
phone. Check the DHCP
configuration.
ESSID Bad ESSID The ESSID on the phone
does not match the SSID on
the AP.
Configure the correct ESSID
statically on the phone.
Flash
Config
Flash Config Error The internal configuration of
the phone is corrupt.
Restore the phone defaults
and enter the configuration
information.
No Net No Net Found The ESSID on the phone
does not match the SSID on
the AP.
Configure the correct ESSID
statically on the phone.
No Net No Net Access The security settings on
the phone do not match the
security settings on the AP.
Check the AP security
settings and configure the
security settings for the
phone to match.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.