Filter
Top Products
Configuration 147
• Parity: None
• Stop bits: 1
• Flow control: None
ATTENTION
If you use Windows 2000, you must install Service Pack 2 to enable
the use of HyperTerminal™.
3 Reset the system.
The following appears on the terminal display:
04830130
4 Type the following command using the terminal or PC keyboard:
0255CC [CTRL M] [CTRL J]
The command does not display on the screen as it is typed.
The Login prompt appears. If an error is made when entering
the command string, the message
Ill Formed Packet
appears. It appears as a series of numbers followed by some
form of the typed command. If this occurs, repeat Step 3 and
Step 4.
5 Enter the default logon name and the default password:admin
admin
admin
admin
The logon name and password are case-sensitive.
The NetLink OAI System screen appears. This screen, the
main menu screen of the Administration Console, displays the
factory-default name of the WLAN Application Gateway 2246 to
which the serial port is connected
--End--
Next, configure the WLAN Application Gateway (including IP address) by
following the steps in the “Task summary list” (page 148).
Configuration
The NetLink OAI System screen is the main menu of the Administration
Console. Use this screen to configure the WLAN Application Gateway
2246.
Administration console navigation
Use the keys described in Table 18 "Administration console navigation"
(page 148) to move around the Administration console screens.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.