Filter
Top Products
Configuration 151
current date and time from the SNTP server and tags syslog
messages with the date.
• IGMP Enabled—configure as Yes or No. IGMP is Internet
Group Routing Protocol. IGMP Enabled allows the WLAN
Application Gateway 2246 to join multicast groups. Enable
this option if the network switch connected to the WLAN
Application Gateway 2246 requires IGMP for multicast traffic
to be forwarded.
•
Maintenance Lock—the system sets this option to Yes after
maintenance activities are performed that require a reset.
This option cannot be changed. It is automatically set. Reset
the system at exit to clear Maintenance Lock. Maintenance
Lock prevents any new calls from starting.
• Press ESC to return to the NetLink OAI System screen.
• Reset the WLAN Application Gateway 2246.
--End--
Connecting to the LAN
Follow the steps in Procedure 16 “Connecting the WLAN Application
Gateway 2246 to the LAN” (page 151) to connect the WLAN Application
Gateway 2246 to the LAN.
Procedure 16
Connecting the WLAN Application Gateway 2246 to the LAN
Step Action
1 Using an RJ-45 cable, connect the NETWORK port of the WLAN
Application Gateway 2246 to the connecting port on the Ethernet
switch.
2 Power up the entire system.
--End--
All components cycle through their usual diagnostic routine.
Connecting to the Application Server
Some applications can require a LAN connection between the Application
Server and the WLAN Application Gateway 2246. If the applications do
not require a LAN connection, use the RS-232 port connection. In some
situations, a modem is connected to be used for remote administration of
the WLAN Application Gateway 2246.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.