Filter
Top Products
Diagnostic Tools 199
2 : mmmm ch - ss
mnem
3 : mmmm ch - ss
mnem
where
C is the AP currently in use.
1, 2, and 3 are the candidate APs.
mmmm is the hexadecimal number comprised of the last
two octets of the AP MAC address.
ch is the channel number that the AP is configured on.
ss is the signal strength for the AP in dBm.
aid is the Association ID of the currently associated
AP.
mnem is a mnemonic that indicates why the handset did
not hand off to this candidate:
Unkn reason unknown
Weak signal strength too weak
Rate One or more basic rates not supported
Full AP cannot handle bandwidth requirements
AthT Authentication Timeout
AthF Authentication Failure
AscT Association Timeout
AscF Association Failure
SecT Security Timeout
SecF Security Failure
Cnfg Configuration error—AP is not configured correctly (check
security, QoS mode, or network infrastructure)
Diagnostics Screen 4 displays the following information:
AssocCount
nnnnn
ReAssocCount
nnnnn
AsssocFailure
nnnnn
ReAssocFail
nnnnn
where
AssocCount is the association count since power up.
ReAssocCount is the reassociation count since power
up.
AssocFailure is the number of association failures
since power up.
ReAssocFail is the number of reassociation failures
since power up.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.