Filter
Top Products
146 WLAN Application Gateway 2246
Procedure 12
Installing the WLAN Application Gateway 2246
Step Action
1 Place the WLAN Application Gateway 2246 on a shelf or
convenient location.
ATTENTION
The WLAN Application Gateway 2246 is physically connected to the
Ethernet switch and can be placed in any convenient location within
325 ft (100 m) of the switch. It can also be rack-mounted.
2 Connect the power plug from the WLAN Application Gateway
2246 power adapter to the power jack on the front (or rear) of
the box.
ATTENTION
IMPORTANT
Use only the power adapter provided by Nortel.
3 Plug the power adapter into an outlet or outlet strip.
4 Apply power to the WLAN Application Gateway 2246.
5 Ensure that the ERROR LED is off and LED 1 is blinking.
--End--
Configuring the WLAN Application Gateway 2246 IP address
You must connect to the WLAN Application Gateway 2246 through a serial
connection to configure the IP address and the network parameters. After
this is done, you can perform administration and further configuration
through a Telnet connection using the Administration Console.
Follow the steps in Procedure 13 “Connecting to the WLAN Application
Gateway 2246 through a serial port” (page 146) to make a serial
connection to the WLAN Application Gateway 2246.
Procedure 13
Connecting to the WLAN Application Gateway 2246 through a serial port
Step Action
1 Using a DB-9 female, null-modem cable, connect the WLAN
Application Gateway 2246 to the serial port of a terminal or PC.
2 Run a terminal emulation program (such as HyperTerminal) or
use a VT-100 terminal with the following configuration:
• Bits per second: 9600
• Data bits: 8
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 03.04 Standard
23 September 2008
Copyright © 2004–2008 Nortel Networks
.