Polycom 6000 Network Router User Manual


 
NetEngine IAD User Guide
WAN Configuration 83
Type the value for the peak cell rate.
7. The IAD saves the configuration and displays the PVC Configuration
menu where you may continue with other PVC management tasks.
8. Reset the IAD (page 15) when you finish PVC configuration.
Modifying a PVC
To modify a PVC, follow these steps:
1. On the ATM PVC Configuration menu, type 2 to select Modify Existing
PVC.
2. The IAD displays the following port table, and a prompt:
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encapsulation) 3641 UBR
2 100 39 RFC 1483 (with LLC Encapsulation 4 CBR
--------
Total = 3645 cps
Maximum PCR this interface can support = 4830 cps
Select Port: [1-8]
Type the port number and press Enter.
3. The IAD displays a prompt for the VPI:
Enter Virtual Port Identifier (VPI):
Type a VPI value between 0 and 255 (default 0) and press Enter.
4. The IAD displays a prompt for the VCI:
Enter Virtual Circuit Identifier (VPI):
Type a VCI value between 32 and 65535 (the default is 38 for data and
39 for voice) and press Enter.
5. The IAD displays the ATM Encapsulation Configuration menu.
Figure 4–40. ATM Encapsulation Configuration Menu
Select the encapsulation you want to assign to this PVC. Proceed to the
corresponding section and perform the steps to set up the encapsulation
you’ve chosen.
*****************************************
ATM Encapsulation Configuration
*****************************************
Current Encapsulation: NONE
1. AAL5 (None)
2. AAL0 (None)
3. Proprietary Voice
4. RFC 1483 (using VC Muxing)
5. RFC 1483 (with LLC Encapsulation)
6. RFC 2364 (PPPoATM with LLC Encapsulation)
7. RFC 2364 (PPPoATM using VC Muxing)
8. AAL1/CES
9. AAL2 (LES, NBT)