Filter
Top Products
NetEngine IAD User Guide
After you have defined the voice PVCs or DLCIs on the IAD, you should
configure the voice path for voice operation to function correctly.
This chapter contains the following topics:
Basic Voice Path Setup Tasks (page 140)
Voice Path Configuration Menu (page 140)
Setting the Voice Gateway (page 141)
Setting Jitter Delay (page 143)
Setting Start Mode (page 143)
Setting SLIC Control Mode (page 144)
Setting Compander Mode (page 145)
Setting On Hook Transmission Mode (page 145)
Setting Idle Voltage Mode (page 146)
Setting Debug Mode (page 147)
Configuring Echo Cancellation (page 147)
Setting Loop Gain (page 148)
Setting Country Mode (page 150)
7. Voice Path
Configuration
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.