Filter
Top Products
NetEngine IAD User Guide
Voice Path Configuration 164
Manual ATM pace control (disabled) [E/D]:
3. Type E to enable pace control, or D to disable pace control.
4. You must reset the IAD (page 15) before this change takes effect.
Setting the Audio Bit Rate Margin
1. Type A to set the audio bit rate margin.
2. The IAD displays:
Audio bit rate margin (0):
3. Enter the new bit rate margin (0 to 50) and press Enter.
4. You must reset the IAD (page 15) before this change takes effect.
Setting the Minimum Signaling Bit Rate
1. Type M to set the audio bit rate margin.
2. The IAD displays:
Minimum signaling bit rate (0):
3. Enter the new bit rate margin and press Enter.
4. You must reset the IAD (page 15) before this change takes effect.
Debugging AAL2/LES Gateways
Displaying AAL2/LES Statistics
Type S to display the AAL2/LES Statistics menu:
Figure 7–25. AAL2/LES Statistics Menu
Type the option for the command to execute and proceed to the
appropriate section.
Displaying Audio/CAS/Alarm Statistics
Type D to display transmitted and received audio, CAS, dropped, and
alarm statistics by line.
Press Escape to return to the menu, or any other key to refresh the
statistics and display the table.
Clearing Statistics
Type C to clear all statistics.
The IAD resets the values to zero and displays the menu.
NOTE
The commands in option D, Debug Control, are reserved for
use by Verilink network engineers only.
************************************
AAL2/LES Statistics
************************************
D. Display Audio/CAS/Alarm Statistics
C. Clear Statistics