Polycom 6000 Network Router User Manual


 
NetEngine IAD User Guide
Router Configuration 123
Copying a Filter
To copy a filter to the filter buffer for viewing or editing, follow these steps:
1. On the IP Filter Copy to Buffer menu, type C to select Copy a filter of
the chosen type to the buffer.
2. The IAD displays the filter table for this interface and prompts for a
filter number:
T1/E1 Output Filters: Enabled
num state action srcLwP srcHiP src.ip.add.low src.ip.add.hi QoS
proto mask dstLwP dstHiP dst.ip.add.low dst.ip.add.hi Level
0 Idle Pass 0 65535 168.192.1.10 255.255.255.25 5
TCP 0H 0 65535 92.100.1.1 255.255.255.255 0
Type the filter number and press Enter.
3. The IAD copies the filter to the filter buffer and displays the IP Filter
Copy to Buffer menu.
Displaying a Filter in the Buffer
To display filter details, follow these steps:
1. On the IP Filter Copy to Buffer menu, type D to the filter currently
stored in the buffer.
2. The IAD displays the filter (Table 5–2 on page 123).
T1/E1 Output Filters: Enabled
num state action srcLwP srcHiP src.ip.add.low src.ip.add.hi QoS
proto mask dstLwP dstHiP dst.ip.add.low dst.ip.add.hi Level
0 Idle Pass 0 65535 168.192.1.10 255.255.255.25 5
TCP 0H 0 65535 92.100.1.1 255.255.255.255 0
When you’re done viewing the details, press any key to return to the IP
Filter Copy to Buffer menu.
Table 5–2. Filter Details
Parameter Description
num number of the filter
state Idle or Active
action Pass or Discard
srcLwP Filter Source Port Low—TCP or UDP packets
only
srcHiP Filter Source Port High—TCP or UDP packets
only
source.ip.addr.low Filter Destination IP Low Address
source.ip.addr.high Filter Source IP High Address
proto Filter protocol—IP, ICMP, IGMP, TCP, UDP