Filter
Top Products
NetEngine IAD User Guide
Router Configuration 127
Config-
uring the
LAN IP
Broadcast
Destination
To set the LAN IP broadcast destination address (where all broadcast IP
packets received on the LAN ports will be redirected), follow these steps:
1. On the Router Configuration menu, type B.
2. The IAD displays the current LAN IP broadcast destination address
and a prompt:
Current LAN IP Broadcast destination Address =
0.0.0.0
Enter new LAN IP Broadcast destination address:
Type the new IP address.
3. The IAD saves the changes and displays the Router Configuration
menu.
4. Continue with other configuration tasks, or press Escape to return to
the Main menu.
5. Reset the IAD (page 15) when you finish configuration.
Displaying
the Route
Table
To display the Route table and view information about statically configured
routes and dynamically learned ones, type D on the Router Configuration
menu.
The IAD displays each network address and related information:
Network AddressNetmask Gateway Address Interface Metric Type
98.1.1.5 255.255.255.0 91.1.1.1
98.1.1.6 255.255.255.0 99.1.1.1
99.9.9.1 255.255.255.0 100.9.9.9
91.1.1.18 255.255.255.255 91.1.1.1 91.1.1.18 1 local
127.0.0.1 255.0.0.0 127.0.0.1 127.0.0.1 1 local
Route Table parameters are described in the following table.
Table 5–3. Route Table Parameters
Parameter Description
Network Address destination address
Netmask IP subnet mask; number of bits reserved
for the host ID
Gateway Address IP address of packets sent to destination
Interface IP address of outgoing interface
Metric number of hops (routers) required to reach
the specified gateway
Type static | dynamic | RIP | local