Filter
Top Products
NetEngine IAD User Guide
WAN Configuration 52
Basic WAN
Setup
Tasks
To set up the IAD for voice and data operation, you must perform at least
these basic tasks:
Select ATM or Frame Relay as the datalink protocol (page 56)
For ATM protocol, configure ATM PVCs (page 81) and ATM options
(page 90)
For Frame Relay protocol, configure Frame Relay DLCIs (page 93)
and Configure Frame Relay options (page 97)
Configure the WAN interface for your IAD (following)
For channelized T1, set up voice and data circuits (page 58)
Configure the voice path (Voice Path Configuration on page 139).
Use the flowcharts below to plan your tasks for configuring either xDSL or
T1/E1 based on your wide area networking requirements.
Figure 4–1. xDSL WAN Configuration Flowchart
SDSL
Module
End
Changing
factory
configuration
?
Ye s
ATM?
Ye s
Ye s
No
No
Select quick
configuration
Define PVCs
Define DLCIs
Configure
ATM options
End
Configure
ATM options
End
Set
maintenance
protocol
Frame
Relay?
Ye s
ATM?
No
Define DLCIs
End
Set
maintenance
protocol
Define PVCs
Frame
Relay?
Ye s
0232