Polycom 6000 Network Router User Manual


 
NetEngine IAD User Guide
WAN Configuration 100
Figure 4–64. Frame Relay Maintenance Protocol Menu
4. Type the number that corresponds to the protocol on your network and
press Enter.
5. Reset the IAD (page 15) for changes to take effect.
Configuring the Congestion Parameters
To configure the congestion parameters:
1. On the WAN Configuration menu.
2. Select Configure FR Options to display the Frame Relay Options menu
(page 97).
3. Select Configure Congestion Parameters to display the FR Congestion
Configuration menu.
Figure 4–65. Frame Relay Congestion Configuration Menu
4. Do one of the following.
A. Select Configure Transmit Congestion Parameters and then follow
the on-screen messages to set:
FECN/BECN condition set size
FECN/BECN condition clear size
FECN/BECN max number of bytes to store
—or—
B. Select Configure Receive Congestion Parameters and then follow
the on-screen messages to:
FECN/BECN condition set size
FECN/BECN condition clear size
FECN/BECN max number of bytes to store
5. Reset the IAD (page 15) for changes to take effect.
*****************************************
Frame Relay Maintenance Protocol
*****************************************
0. None
1. CCITT Q.933 Annex A Network
2. CCITT Q.933 Annex A User
3. CCITT Q.933 Annex A Both
4. ANSI T1.617 Annex D Network
5. ANSI T1.617 Annex D User
6. ANSI T1.617 Annex D Both
7. LMI Network (FRF.1.1)
8. LMI User (FRF.1.1)
9. LMI Both (FRF.1.1)
*****************************************
* FR Congestion Configuration *
*****************************************
1. Configure Transmit Congestion Parameters
2. Configure Receive Congestion Parameters