Polycom 6000 Network Router User Manual


 
NetEngine IAD User Guide
Voice Path Configuration 143
Displaying
Jitter Delay
To display the current jitter delay value, type D on the Voice Configuration
menu. The IAD displays the current value:
Jitter Delay: 12 ms
Press any key to display the Voice Configuration menu and continue.
Setting
Start Mode
To set start mode (for POTS only), type S on the Voice Configuration menu
to display the Start Mode Selection menu:
Figure 7–4. Start Mode Selection Menu
Type the option for the task to perform. Proceed to the appropriate section.
Setting All Ports to Loop Start
1. Type 1 to select Set All Ports to Loop Start.
2. The IAD sets all ports to Loop Start and saves the configuration.
3. Press any key to return to the Start Mode Selection menu.
4. Press Escape to continue with other voice path configuration.
5. Reset the IAD (page 15) when you finish voice path configuration.
Setting All Ports to Ground Start
1. Type 2 to select Set All Ports to Ground Start.
2. The IAD sets all ports to Ground Start and saves the configuration.
3. Press any key to return to the Start Mode Selection menu.
4. Press Escape to continue with other voice path configuration.
5. Reset the IAD (page 15) when you finish voice path configuration.
Displaying Start Mode
1. To display a list of telephone ports and their current start mode, type 3.
2. The IAD displays a list similar to this:
Port: 1 Mode: Loop Start
Port: 2 Mode: Loop Start
Port: 3 Mode: Loop Start
Port: 4 Mode: Loop Start
3. Press any key to return to the Start Mode Selection menu.
4. Press Escape to continue with other voice path configuration.
*******************************************
Start Mode Selection
*******************************************
1. Set All Ports to Loop Start
2. Set All Ports to Ground Start
3. Display Start Mode
4. Configure Individual Port