Filter
Top Products
NetEngine IAD User Guide
Voice Path Configuration 152
Available Interfaces:
1. G2237 xDSL
2. 10/100BaseT Ethernet
0. (Abort)
Selection:
Type the option number to select the signaling interface for MGCP to
use (typically the WAN interface).
5. The IAD displays the port table for this interface and prompts for a port.
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encap)3641 UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to configure and press Enter.
6. The IAD displays the bracketing prompt:
Enter option for using hostname with "[]" for
Signaling:
Type Y to wrap the port in brackets for call agent API compatibility, or N
and press Enter.
7. The IAD prompts for the outbound signaling packets TOS field value:
Enter the TOS byte value to use for Signalling
packets [1-7]:
Type the field value and press Enter.
8. The IAD prompts for the RTP transport packets TOS field value:
Enter the TOS byte value to use for RTP (Voice)
packets [1-7]:
Type the field value and press Enter.
9. The IAD saves the settings and displays the menu so you may
continue configuring MGCP/NCS.
10. Reset the IAD (page 15) when you finish voice path configuration.
Displaying MGCP Statistics
Type S to display the endpoint (line) and connection statistics. If no calls
are active, the IAD indicates if the Endpoint is currently connected to its
Notified Entity or not.
If MGCP configuration is not correct, the IAD displays this warning
message:
Configuration Invalid, initialization incomplete.
Debugging MGCP
The commands displayed on the Debug MGCP menu are reserved for
Verilink network engineers.
Removing a Connection
Type R to remove a lost connection.
Type the number of the Connection ID to delete and press Enter.