Filter
Top Products
NetEngine IAD User Guide
Multicast Configuration 184
Adding a
Multicast
Routing
Source
Type A to add a Multicast Routing Source. The IAD creates a multicast
routing source and adds it to the Multicast Routing Source Table.
1. The IAD displays the IP address prompt:
Enter IP address for the Source:
Type the source IP address and press Enter.
2. The IAD displays the current subnet mask and prompt:
Enter subnet mask for the source:
(255.255.255.0) ->
Type the new subnet address and press Enter.
3. The IAD displays the available interfaces and a prompt:
Available Interfaces:
1. G2237 xDSL
2. 10/100BaseT Ethernet
0. (Abort)
Selection:
Type the option number to select the interface.
4. The IAD displays the port table for this interface and prompts for a port.
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encap)3641 UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to configure and press Enter.
5. The IAD saves the new configuration and displays the Multicast
Configuration menu.
6. Reset the IAD (page 15) for changes to take effect.