Polycom 6000 Network Router User Manual


 
NetEngine IAD User Guide
Voice Path Configuration 146
Setting Idle
Voltage
Mode
To set idle high voltage for loop start lines (POTS only), type L to display
the Loop Start Idle Voltage Selection menu:
Figure 7–8. Ground Start OHT Mode Selection Menu
Type the option for the task to perform. Proceed to the appropriate section.
Enabling and DIsabling Idle High Voltage Globally
1. Type 1 to enable or disable idle high voltage for all ports.
2. The IAD displays the following prompt:
Enter E to Enable, D to Disable:
Type E to enable idle high voltage for all ports, or D to disable it.
3. The IAD saves the mode you’ve selected and displays the menu.
4. Press Escape to return to the Voice Configuration menu and continue
with other voice path configuration.
Displaying Idle High Voltage Settings
Type 2 to display the idle high voltage setting on each port.
The IAD displays the following report:
1 Low Voltage
2 Low Voltage
3 Low Voltage
4 Low Voltage
Press any key to return to the Loop Start Idle Voltage Selection menu.
Enabling and DIsabling Idle High Voltage for a Specific Port
1. Type 3 to enable or disable idle high voltage for a specific port.
2. The IAD displays the port prompt:
Select Line: [1-8]
Type the port number to set.
3. The IAD displays the following prompt:
Enter E to Enable, D to Disable:
Type E to enable idle high voltage, or D to disable it.
4. The IAD saves the mode you’ve selected and displays the menu.
5. Press Escape to display the Voice Configuration menu and continue
with other voice path configuration.
Reset the IAD
Reset the IAD (page 15) when you finish voice path configuration.
*******************************************
Loop Start Idle Voltage Selection
*******************************************
1. Enable/Disable Loop Start Idle High Voltage for all ports
2. Display current Loop Start Idle High Voltage settings
3. Enable/Disable Loop Start Idle High Voltage Setting per port