Filter
Top Products
6 – Removal/Replacement
Fans
59043-06 A 6-19
0
6.6.1
Removing a Fan
To remove a fan, loosen the two captive screws shown in Figure 6-8 with a flat-
blade screw driver. Grasp the fan by the screws and pull firmly to disengage the
fan from the backplane connector. Slide the fan out of the chassis.
Figure 6-8. Removing a Fan
WARNING!! Voltage is present in an open bay when the switch is operating. To
avoid personal injury, do not place hands or objects into an open
bay.
AVERTISSEMENT!!
Lorsque le commutateur est en marche, la baie ouverte est sous
tension. Pour éviter toute blessure personnelle, ne pas placer les
mains ou des objets dans une baie ouverte.
WARNUNG!!
In einem offenen Gestell ist Spannung vorhanden, wenn der
Switch in Betrieb ist. Zur Vermeidung von Verletzung weder die
Finger noch irgendwelche Objekte in ein offenes Gestell
einführen.
CAUTION!
Replacement fans must be compatible with the switch air flow
direction of the other fans. Installing a fan with an opposing air
flow direction could lead to an over temperature condition.
To avoid overheating, do not operate the switch without a fan any
longer than it takes to install a new fan.
Screws