Filter
Top Products
B – Command Line Interface
Set Config Command
59043-06 A B-45
0
InteropMode Propagates just the active zone set
throughout the fabric (True, compliant)
or the entire zoning database (False,
non-compliant). The default is True.
LegacyAddressFormat Available only when the InteropMode
parameter is False, this parameter
enables (True) or disables (False) the
use of legacy address formatting for
interoperating with non-FC-SW-2
switches. Refer to “InteropMode” on
page B-45. The default is False.
Table B-10. Set Config Switch Parameters (Continued)
Parameter Description