Filter
Top Products
B – Command Line Interface
Set Command
59043-06 A B-37
0
Set Command
Sets a variety of switch parameters.
Authority Admin session for all keywords except Alarm, Beacon, and Pagebreak which are
available without an Admin session.
Syntax set
alarm [option]
beacon [state]
blade [slot_number] [state]
config [option]
log [option]
pagebreak [state]
port [option]
setup [option]
switch [state]
Keywords alarm [option]
Controls the display of alarms in the session output stream or clears the alarm log.
[option] can be one of the following:
clear
Clears the alarm log history. This value requires an Admin session.
on
Enables the display of alarms in the session output stream.
off
Disables the display of alarms in the session output stream.
beacon [state]
Enables or disables the flashing of the Port Status LEDs according to [state]. This
keyword does not require an admin session. [state] can be one of the following:
on
Enables the flashing beacon.
off
Disables the flashing beacon.
blade [slot_number] [state]
Temporarily changes the administrative state given by [state] for all ports on the
I/O blade occupying the slot given by [slot_number]. The previous Set Config
Switch settings are restored after a switch reset or a reactivation of a switch
configuration. [slot_number] is a number in the ranges 1–4 and 6–9. [state] can be
one of the following:
online
Places the I/O blade and its ports online.
offline
Places the I/O blade and its ports offline.