Filter
Top Products
58
Creating a Patch
●
Apply the LFO immediately when the key is
pressed, and then gradually begin to
decrease the effect
fig.LFO-2.e
Fade Mode:
ON >
Delay Time:
The time that the LFO will continue after the keyboard
is played.
Fade Time:
The time over which the LFO amplitude will reach the
minimum after the Delay Time has elapsed.
●
Apply the LFO gradually after the key is
released
fig.LFO-3.e
Fade Mode:
OFF <
Delay Time:
The time from when the keyboard is released until the
LFO begins to be applied.
Fade Time:
The time over which the LFO amplitude will reach the
maximum after the Delay Time has elapsed.
●
Apply the LFO from when the key is pressed
until it is released, and gradually begin to
decrease the effect when the key is released
fig.LFO-4.e
Fade Mode:
OFF >
Delay Time:
The time that the LFO will continue after the keyboard
is released.
Fade Time:
The time over which the LFO amplitude will reach the
minimum after the Delay Time has elapsed.
Apply Portamento or Legato to the
Sound (Solo Porta)
fig.03-20_50
For details on the setting, refer to
“How to Make the Patch
Settings”
(p. 39).
Mono/Poly
Specifies whether the patch will play polyphonically (POLY) or
monophonically (MONO). The “MONO” setting is effective when
playing a solo instrument patch such as sax or flute.
Value
MONO:
Only the last-played note will sound.
POLY:
Two or more notes can be played simultaneously.
Legato Switch (Legato Switch)
Legato Switch is valid when the Mono/Poly parameter is set to
“MONO.” This setting specifies whether the Legato Switch will be
used (ON) or not (OFF).
With the Legato Switch parameter “ON,” pressing a key while
continuing to press a previous key causes the note to change pitch to
the pitch of the most recently pressed key, sounding all the while.
This creates a smooth transition between notes, which is effective
when you wish to simulate the hammering-on and pulling-off
techniques used by a guitarist.
Value:
OFF, ON
Legato Retrigger (Legato Retrigger Switch)
The Legato Retrigger is valid when the Mono/Poly parameter is set
to “MONO” and the Legato Switch parameter is set to “ON.” The
setting determines whether sounds are replayed (ON) or not (OFF)
when performing legato. Normally you will leave this parameter
“ON.” When “OFF,” when one key is held down and another key is
then pressed, only the pitch changes, without the attack of the latter
key being played. Set this to “OFF” when performing wind and
string phrases or when using modulation with the mono synth
keyboard sound.
Value:
OFF, ON
Note on
high (more)
low (less)
Delay Time
Fade Time
Depth
Pitch
Cutoff Frequency
Level
Pan
high (more)
low (less)
Delay
Time
Fade Time
Depth
Note
off
Note
on
Pitch
Cutoff Frequency
Level
Pan