Filter
Top Products
63
Creating a Patch
Creating a Patch
●
Changing the TVF Envelope
TVA ENV A-TIME:
Changes the Env Time 1 parameter of the TVA
envelope.
TVA ENV D-TIME:
Changes the Env Time 2 and Env Time 3
parameters of the TVA envelope.
TVA ENV R-TIME:
Changes the Env Time 4 parameter of the TVA
envelope.
●
Splitting Tones That Are Played
TMT
• If the Matrix Control is used to split tones, set the TMT Vel
Control parameter to “OFF,” and the TMT Control Switch
parameter to “ON” (p. 48).
• If the Matrix Control is used to split tones, we recommend
setting the Matrix Control Sens to “+63.” Selecting a lower value
may prevent switching of the tones. Furthermore, if you want to
reverse the effect, set the value to “-63.”
• If you want to use matrix control to switch smoothly between
tones, use the Velo Fade Lower and Velo Fade Upper parameters
(p. 48). The higher the values set, the smoother the switch is
between the tones.
●
Changing the Depth of Frequency
Modulation for FXM
FXM DEPTH
●
Controlling the amount of realtime stretch/
shrink
TIME
This will have no effect if Realtime Time Stretch (p. 45) is not
selected. If matrix control sensitivity is set to “+” the stretch/
shrink time will become shorter, and if set to “-” the time will
become longer.
●
Changing Specific Multi-Effects Parameters
MFX CTRL1–4:
Change the parameter that was specified by MFX
Control 1–4 Assign parameter.
No effects are available, even with the Matrix Control, when the
settings are such that no multi-effects are applied.
CTRL Sens 1–4 (Matrix Control Sens 1–4)
Sets the amount of the Matrix Control’s effect that is applied. If you
wish to modify the selected parameter in a positive (+) direction –
i.e., a higher value, toward the right, or faster etc. – from its current
setting, select a positive (+) value. If you wish to modify the selected
parameter in a negative (-) direction – i.e., a lower value, toward the
left, or slower etc. – from its current setting, select a negative (-)
value. When both positive and negative are selected, the changes are
greater as the value increases. Set it to “0” if you don’t want this
effect.
Value:
-63– +63
CTRL Tone 1–4 (Tone Control Switch 1–4)
Matrix Control Tone selects the tone to which the effect is applied
when using the Matrix Control.
Value
OFF:
The effect will not be applied.
ON:
The effect will be applied.
REVS:
The effect will be applied in reverse.
Setting Effects for a Patch (Effects/
MFX/MFX Control/Chorus/Reverb)
For details regarding effect settings, refer to the pages shown
below.
•
“Applying Effects in Patch Mode”
(p. 175)
•
“Making Multi-Effects Settings (MFX1–3)”
(p. 180)
•
“Making Chorus Settings (Chorus)”
(p. 182)
•
“Making Reverb Settings (Reverb)”
(p. 182)
Reference_e.book 63 ページ ２００３年７月１４日 月曜日 午後３時２５分