Filter
Top Products
5-23
5
SADDLE STITCH FINISHER
9
Turn roller rotating knob A in the direction
of the arrow to move the staple unit to the
front.
Turn the roller rotating
knob until the triangle
mark is aligned with the
index.
10
Remove the staple box.
11
Raise the lever at the end of the staple box.
Remove the top staple if
it is bent. If bent staples
remain, a staple jam will
occur again.
12
Return the lever to its original position.
13
Reinstall the staple box.
Push the staple box in
until it clicks into place.
14
Push the stapler section back into the
finisher.
15
Close the front cover.
16
Push the saddle stitch finisher back against
the printer.
NOTE
Make a test print or copy in the staple sort mode to
ensure that stapling is performed properly.
■ Disposal of hole punch scrap
3
Return the punch scrap collecting
container to its original position.
4
Push the saddle stitch finisher back against
the printer.
Roller rotating knob A
Staple unit
1
Unlatch the saddle stitch finisher and slide
it away from the printer.
2
Pull out the punch scrap collecting
container and empty it.