Filter
Top Products
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i 227 Revision 1.4 (08-19-08)
DATASHEET
14.2.5.23 1588 Interrupt Status and Enable Register (1588_INT_STS_EN)
This read/write register contains the IEEE 1588 interrupt status and enable bits.
Writing a 1 to any of the interrupt status bits acknowledges and clears the interrupt. If enabled, these
interrupt bits are cascaded into bit 29 (1588_EVNT) of the Interrupt Status Register (INT_STS). Writing
a 1 to any of the interrupt enable bits will enable the corresponding interrupt as a source. Status bits
will still reflect the status of the interrupt source regardless of whether the source is enabled as an
interrupt in this register. Bit 29 (1588_EVNT_EN) of the Interrupt Enable Register (INT_EN) must also
be set in order for an actual system level interrupt to occur. Refer to Chapter 5, "System Interrupts,"
on page 49 for additional information.
Offset: 198h Size: 32 bits
BITS DESCRIPTION TYPE DEFAULT
31:25 RESERVED RO -
24
1588 Port 2 RX Interrupt Enable (1588_PORT2_RX_EN) R/W 0b
23
1588 Port 2 TX Interrupt Enable (1588_PORT2_TX_EN) R/W 0b
22
1588 Port 1 RX Interrupt Enable (1588_PORT1_RX_EN) R/W 0b
21
1588 Port 1 TX Interrupt Enable (1588_PORT1_TX_EN) R/W 0b
20
1588 Port 0(Host MAC) RX Interrupt Enable (1588_MII_RX_EN) R/W 0b
19
1588 Port 0(Host MAC) TX Interrupt Enable (1588_MII_TX_EN) R/W 0b
18
GPIO9 1588 Interrupt Enable (1588_GPIO9_EN) R/W 0b
17
GPIO8 1588 Interrupt Enable (1588_GPIO8_EN) R/W 0b
16
1588 Timer Interrupt Enable (1588_TIMER_EN) R/W 0b
15:9
RESERVED RO -
8
1588 Port 2 RX Interrupt (1588_PORT2_RX_INT)
This interrupt indicates that a packet received by Port 2 matches the
configured PTP packet and the 1588 clock was captured.
R/WC 0b
7
1588 Port 2 TX Interrupt (1588_PORT2_TX_INT)
This interrupt indicates that a packet transmitted by Port 2 matches the
configured PTP packet and the 1588 clock was captured.
R/WC 0b
6
1588 Port 1 RX Interrupt (1588_PORT1_RX_INT)
This interrupt indicates that a packet received by Port 1 matches the
configured PTP packet and the 1588 clock was captured.
R/WC 0b
5
1588 Port 1 TX Interrupt (1588_PORT1_TX_INT)
This interrupt indicates that a packet transmitted by Port 1 matches the
configured PTP packet and the 1588 clock was captured.
R/WC 0b
4
1588 Port 0(Host MAC) RX Interrupt (1588_MII_RX_INT)
This interrupt indicates that a packet from the switch fabric to the Host MAC
the matches the configured PTP packet and the 1588 clock was captured.
Note: For Port 0, receive is defined as data from the switch fabric, while
transmit is
to the switch fabric.
R/WC 0b