Filter
Top Products
Getting Started
3-3
3.3 Default Configuration Changes
The following table illustrates the changes made to the AP-5131 version 1.1 configuration as
compared to the 1.0 version configuration:
3.4 Initially Connecting to the Access Point
3.4.1 Connecting to the Access Point using the WAN Port
To initially connect to the AP-5131 using the access point’s WAN port:
1. Connect AC power to the AP-5131, as Power-Over-Ether support is not available on the WAN
port.
2. Start a browser and enter the AP-5131’s static IP WAN address (10.1.1.1). The default
password is “symbol.”
3. Refer to Basic Device Configuration on page 3-5 for instructions on the initial (basic)
configuration of the AP-5131.
Version 1.0 Version 1.1
WAN DHCP client
Auto-Update Enabled
Static IP: 10.1.1.1
Static Mask: 255.0.0.0
LAN 1 Static IP: 192.168.0.1
Static Mask: 255.255.255.0
DHCP Server Enabled
DHCP Client
Auto-Update Enabled
Default Gateway
Ethernet Port Enabled
LAN 2 Not applicable in 1.0 release Static IP: 192.168.1.1
Static Mask: 255.255.255.0
DHCP Server Enabled
Access via WAN
port
HTTPS, SSH, SNMP: Enabled HTTP, HTTPS, SSH, SNMP, Telnet:
Enabled
NOTE The procedures described below assume this is the first time you are
connecting to the access point.