Filter
Top Products
System Configuration
4-21
3. Configure the SNMP v3 User Definitions field (if SNMP v3 is used) to add and configure
SNMP v3 user definitions.
SNMP v3 user definitions allow read-only or read/write access to management information
as appropriate.
Delete Select Delete to remove a SNMP v1/v2c community definition.
Community
Use the Community field to specify a site-appropriate name for
the community. The name is required to match the name used
within the remote network management software.
OID Use the OID (Object Identifier) pull-down list to specify a setting of
All or a enter a Custom OID. Select All to assign the user access to
all OIDs in the MIB. The OID field uses numbers expressed in dot
notation.
Access Use the Access pull-down list to specify read-only (R) access or
read/write (RW) access for the community. Read-only access
allows a remote device to retrieve AP-5131 information, while
read/write access allows a remote device to modify AP-5131
settings.
Add
Click Add to create a new entry for an SNMP v3 user.
Delete Select Delete to remove an entry for an SNMP v3 user.
Username
Specify a username by typing an alphanumeric string of up to 31
characters.
Security Level Use the Security Level area to specify a security level of noAuth
(no authorization), AuthNoPriv (authorization without privacy), or
AuthPriv (authorization with privacy).
The NoAuth setting specifies no login authorization or encryption
for the user.
The AuthNoPriv setting requires login authorization, but no
encryption.
The AuthPriv setting requires login authorization and uses the
Data Encryption Standard (DES) protocol.
OID Use the OID (Object Identifier) area to specify a setting of All or
enter a Custom OID. Select All to assign the user access to all OIDs
in the MIB. The OID field uses numbers expressed in dot notation.