Filter
Top Products
3 Tests and Diagnostics 3.3 Setting of the hardware configuration
• Setting of the HWSC
• Setting of the UUID
• Display of the DMI information (including UUID)
• Setting of DVD region code (Yes/No)
After completion of the above settings, H/W configuration & DMI
information are appeared in order. Check the contents and press Enter.
Subtest 02 Region write
This subtest sets the region code for DVD drive based on the destination of
the machine.
When the region code has been already written, test ends without setting.
The following message appears in the display after setting the region code.
Press any key to return to the H/W initial information setting tool menu.
***********************************
******* It completed *******
***********************************
* *
Press any key to continue...
Subtest 03 DMI information save
This is one of tools to copy the DMI information to a new PCB after
replacing.
This subtest saves all the DMI data in a floppy disk.
Subtest 04 DMI information recovery
This is one of tools to copy the DMI information to a new PCB after
replacing.
This subtest writes all the DMI data in the floppy disk into the new PCB.
NOTE: Since the data of UUID is updated every time when this subtest, DMI information
recovery, is done, the saved UUID data is not written.
QOSMIO F10 Maintenance Manual (960-498) 3-9