Filter
Top Products
4.23 LCD unit/FL inverter 4 Replacement Procedures
4.23 LCD unit/FL inverter
Removing the LCD unit/FL inverter
The following describes the procedure for removing the LCD unit and FL inverter (See
Figure 4-39 to 4-42).
1. Open widely the display panel and pull up both the hinge caps to remove by slightly
pressing them toward the display.
2. Peel off two mask tapes and remove the following screws securing the display mask.
• M2.5×6B FLAT BIND screw x2
3. Insert your fingers between the edge of the display mask and the LCD, and remove
the display mask while unlatching the display mask.
Mask tapes
Hinge caps
Display mask
M2.5x6B FLAT BIND
LCD
Figure 4-39 Removing the display mask
4-58 QOSMIO F10 Maintenance Manual (960-498)