Filter
Top Products
4.6 Switch membrane 4 Replacement Procedures
4.6 Switch membrane
Removing the switch membrane
The following describes the procedure for removing the switch membrane (See Figure 4-11).
1. Remove the following screw and remove the LCD CON holder.
• M2.5×6B FLAT BIND screw x1
2. Disconnect the switch membrane from the connector CN9650 on the system board.
3. Remove the following screw fixing the membrane switch.
• M2.5×2.8B FLAT BIND screw x1
4. Slide the switch membrane to the arrow direction and remove it.
M2.5x6B FLAT BIND
LCD CON holde
r
Switch membrane
M2.5x2.8B FLAT BIND
Core
CN9650
Figure 4-11 Removing the switch membrane
4-22 QOSMIO F10 Maintenance Manual (960-498)