Filter
Top Products
4 Replacement Procedures 4.18 Speaker/VGA fan
4.18 Speaker/VGA fan
Removing the Speaker/VGA fan
The following describes the procedure for removing the speaker and VGA fan (See Figure 4-
33).
1. Pull out the speaker cable L (red cable) under the insulator and the glass tapes.
2. Remove the speaker L from the guide of base assembly.
3. Remove the speaker R from the guide of base assembly.
4. Remove the following screws securing the VGA EARTH SPRINGs and remove
them.
• M2×3C SUPER THIN HEAD screw x2
5. Remove the following screws securing the VGA fan.
• M2×4B BIND screw x2
6. Remove the VGA fan from the base assembly
M2.5x4B FLAT BIND VGA EARTH SPRINGs
Speaker R
M2.5x4B FLAT BIND
Rib
Glass tapes
Insulato
r
Speaker cable L
Rib
VGA fan
Speaker L
Figure 4-33 Removing the speakers
QOSMIO F10 Maintenance Manual (960-498) 4-49