Toshiba 960-498 Personal Computer User Manual


 
4.23 LCD unit/FL inverter 4 Replacement Procedures
Installing the LCD unit/FL Inverter
The following describes the procedure for installing the LCD unit and FL inverter (See
Figure 4-39 to 4-42).
1. Secure the LCD supports (left and right) to the LCD unit with the following screws.
M2×3C SUPER THIN HEAD screw x4
2. Stand the LCD unit on the display cover and connect the LCD harness to the
connector on the back of LCD.
3. Stick the aluminum tape on the connector of LCD harness.
4. Secure the LCD unit with the following screws.
M2×4Z SUPER THIN HEAD screw x4
5. Connect LCD harnesses to the connector CN1 and CN2 of the FL inverter.
CAUTION: Be careful not to connect the LCD harnesses to the wrong connectors.
6. Connect HV harnesses to the connector CN3 and CN4 of the FL inverter.
7. Install the FL inverter while sticking the double-sided tape and secure it with the
following screw.
M2×4Z SUPER THIN HEAD screw x1
8. (for model with wireless LAN or Bluetooth)
Insert one insulator under the LCD unit and stick the other one to the FL inverter.
9. Install the display mask and lock the latches.
NOTE: When installing the display mask, ensure that there is no gap between the display
mask and the display cover.
10. Secure the display mask with the following screws and stick two mask tapes on the
front.
M2.5×6B THIN HEAD screw x2
11. Install the hinge caps to the both sides.
4-62 QOSMIO F10 Maintenance Manual (960-498)