Filter
Top Products
4 Replacement Procedures 4.21 SJ board
4.21 SJ board
Removing the SJ board
The following describes the procedure for removing the SJ board (See Figure 4-37).
1. Disconnect the microphone cable from the connector CN6000 on the SJ board.
2. Unlock the connector CN9560 on the SJ board and disconnect the SJ board flat
cable from it.
3. Remove the following screw fixing the SJ board and remove the SJ board.
• M2×4Z BIND screw x1
4. Remove the glass tape and pull out the SJ board flat cable from the slit of the
middle frame.
M2x4Z BIND
SJ board flat cable
Guide lines
Insulator
CN9560
Glass tape
SJ board
Slit
CN6000
Microphone cable
Figure 4-37 Removing the SJ board
QOSMIO F10 Maintenance Manual (960-498) 4-55