Filter
Top Products
Adjusting the Print Density
6-12
❖
4520/4520mp User’s Guide
The print density was adjusted at the factory to provide
optimum print quality and does not normally require any
adjustment. Should you desire to darken or lighten the print
density, perform the following procedure:
1
Open the top cover by
pressing the top cover
release latch.
2
Raise the green handle
on the paper transport
cover and locate the
print density
adjustment knob at the
right rear of the
printer. Turn the knob
to the right (clockwise)
for darker prints, or to
the left
(counterclockwise) for
lighter prints.
Adjusting the
Print Density
WUG-CH06 Page 12 Black,Red,Cyan Sunday, January 22, 1995 8:38 PM